Text
Title 16: Commercial Practices
CHAPTER II: CONSUMER PRODUCT SAFETY COMMISSION
SUBCHAPTER C: FEDERAL HAZARDOUS SUBSTANCES ACT REGULATIONS
PART 1512: REQUIREMENTS FOR BICYCLES
Subpart A: Regulations
1512.10 - Requirements for tires.
The manufacturer's recommended inflation pressure shall be molded into or onto the sidewall of the tire in lettering no less than 3.2 mm (1/8 in.) in height. The statement of recommended inflation pressure shall be in the English language utilizing Arabic numerals. (The following language is suggested to indicate recommended inflation pressure: ?Inflate to __ PSI.?) After inflation to 110 percent of the recommended inflation pressure, the tire shall remain intact on the rim, including while being tested under a load of 2,000 N (450 lbf) in accordance with the rim test, ? 1512.18(j). Tubular sew-up tires, nonpneumatic tires, and nonmolded wired-on tires are exempt from this section.
Sponsored links
